How to Make a Privacy LCD Monitor.You can only see with magic glasses.

How to Make a Privacy Monitor out of an LCD Monitor

Do you have an old LCD monitor at home? You can turn it into a “spy” monitor. While everybody sees it as a monitor with white screen, you will have special “magic” glasses to make it work. Here is an instruction on how to make a privacy monitor out of an LCD monitor.

You’ll need an LCD monitor, old glasses (disposable 3D glasses or sunglasses are fine), paper cutter, screwdriver, paper towels, superglue and paint thinner.

And away we go!

Thanks to Cut Your Way for these amazing instructions

1. Find an old monitor to work with and unscrew all the screws on the back of it to remove the plastic frame.

 

2.  Cutting a Polarizing Film

Most LCD monitors’ glass is covered with two films, a polarized one to filter out the light you are not supposed to see, and a frosted anti-glare film. We don’t need the anti-glare film. We’ll use the polarized film only for our glasses.

Grab your cutting knife and cut the films along the edge. Don’t be afraid to press hard. The metal will not scratch the glass unless it’s covered with sand or other abrasives.  Then, start peeling. Make sure to save the polarized film, also remember the orientation.

3. Clean the Adhesive

Once you have removed the films, the glue has likely remained stuck to the glass. Here comes the messy part. Use solvent to soften the glue and wipe it off with paper towels.Try to cover the screen with paper towels soaked in paint thinner. Or use a piece of wood or plastic to scrape off the soft glue. Be careful not to get paint thinner on the plastic frame, because it will dissolve it.

4.  Your Monitor is Ready.
After cleaning the adhesive, assemble everything back the way it was. Before even making the glasses, you can test the monitor with the polarized film.

5. Pop the Lenses Out
Whatever glasses you are using, pop the lenses out of them or take your glasses apart if it is possible.

6.  Scan, Trace and Cut
If you are going to use a cnc blade or laser cutter, scan and trace the parts.

These frames were scanned so that they could be used as a reference for the lens orientation. Remember, this is a polarized film so the angle is critical. Back and front also matters.

You can also tape the old lenses on the film and then cut them out with an x-acto knife.

 

7.  Reassemble Glasses
It’s time to assemble the glasses. Are you ready for some fun?
People might think you are crazy as they see you staring at a blank white screen and wearing sunglasses.  That makes it even more fun, doesn’t it?

 

Finally you can do something with that old LCD monitor you have in the garage.
You can turn it into a privacy monitor! It looks all white to everybody except you, because you are wearing "magic" glasses!

 

Categories: Science and Technology